the number of digital auxiliaries that a GO device monitors). The two digits for bytes in the custom parameter above is an 8-bit long hexadecimal number that corresponds to an AUX number ranging from 1 to 8 (i.e. The information entered into the bytes section of the parameter specifies the auxiliaries that are configured to a manual state. Input Impedance of each AUX : 30.3 kΩ or 80.6 kΩ (depending on input voltage range)ĭriving Circuit Resistance must be less than 100 ΩĪutomatically identifies GND-Float, Float-Driven and GND-Driven driving circuits with capacitive loading of Īdditionally, to configure an auxiliary to operate with the three circuit types listed above, the following custom parameter must be applied. Supports GND–Float, GND–Driven, and Float–Driven circuitsĪUX1, AUX2, AUX3, AUX4 or AUX5, AUX6, AUX7, AUX8.Monitor up to 8 inputs at any time with two IOX-AUXMs.The IOX-AUXM monitors up to eight signals from your vehicle in real-time - providing additional insight into the condition of your fleet. For the most up to date version, please visit : goo.gl/srUWJY
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |